Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. A suspension bracket and a steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward bearings of a nave
   11.4. A forward rack
   11.5. Repair of a forward rack
   11.6. The bottom lever of a forward suspension bracket
   11.7. The bottom spherical hinge of a forward suspension bracket
   11.8. The stabilizer of cross-section stability of a forward suspension bracket
   11.9. A side scene of the stabilizer of cross-section stability of a forward suspension bracket
   11.10. The bottom frame of a forward suspension bracket
   11.11. A nave of a back wheel
   11.12. Replacement of bearings of a back nave
   11.13. The shock-absorber of a back suspension bracket
   11.14. A cylindrical spring of a back suspension bracket
   11.15. A pin of a nave of a back suspension bracket
   11.16. The bottom lever of a back suspension bracket
   11.17. The top lever of a back suspension bracket
   11.18. The directing lever of a back suspension bracket
   11.19. Draught of a back suspension bracket
   11.20. The stabilizer of cross-section stability of a back suspension bracket
   11.21. A side scene of the stabilizer of cross-section stability of a back suspension bracket
   11.22. A steering wheel
   11.23. A steering column
   11.24. An intermediate shaft of a steering column
   11.25. The ignition lock
   11.26. The steering mechanism
   11.27. Replacement of protective covers of the steering mechanism
   11.28. Removal of air from system of a steering with the amplifier
   11.29. The pump of the amplifier of a steering
   11.30. The spherical hinge of steering draught
   11.31. Steering draught
   11.32. Corners of installation of wheels
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

11.8. The stabilizer of cross-section stability of a forward suspension bracket
THE GENERAL DATA

The prevention

For fastening of a side scene of the stabilizer it is necessary to use new nuts.


Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove forward wheels.
2. Unscrew nuts of fastening of the left and right side scenes to the stabilizer of cross-section stability.
3. Unscrew bolts and nuts of fastening of a suspension bracket of the stabilizer to the top part of the bottom frame (it is specified by an arrow).
4. Remove the stabilizer from under the car.
5. Check up the stabilizer on deterioration and mechanical damages. Special attention give to a condition of plugs of installation of the stabilizer.

Installation

PERFORMANCE ORDER
1. Establish rubber plugs of installation on the stabilizer. Arrange each plug on the stabilizer so that the flat surface of the plug was in the basis, and internal washers are correctly combined with washers on the stabilizer. The plug crack should be directed to a back part.
2. Establish the stabilizer on the bottom frame. Establish installation clips so that their ends have been correctly located in the bottom frame. Fix their bolts and nuts. Connect side scenes to the ends of the stabilizer and tighten bolts of fastening by the demanded moment.
3. Establish new nuts on side scenes and tighten their demanded moment.
4. Establish wheels and lower the car.