Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10. Brake system
THE GENERAL DATA

According to the destination and to carried out functions the brake system of the car is subdivided on working, spare, lay and emergency.

The working brake system provides regulation of speed of the car and its stop with necessary efficiency. Spare serves for a stop of the car with necessary efficiency at failure of working brake system.

The lay serves for car deduction are motionlessly rather expensive. To it basically use for deduction of the standing car, but it can be applied and as emergency at failure of working brake system.

On the car the working brake system with a hydraulic drive and diagonal division of contours is applied that considerably raises safety of driving of the car. At refusal of one of contours as spare brake system the second contour providing a stop of the car with sufficient efficiency is used.

The brake system consists of the main brake cylinder, the vacuum amplifier of brakes, disk brakes on forward wheels and drum-type or disk brakes on back wheels.

The vacuum amplifier of brakes reduces effort a brake pedal, facilitating thereby driving.

The regulator of pressure of back brakes is located in a hydrodrive on each back brake. On the majority of models pressure regulators are located separately, but on some models with back brake drums pressure regulators are united with back working cylinders.

On cars with diesel engines for creation of the vacuum which is ensuring functioning of the vacuum amplifier of brakes, the separate vacuum pump which is established on the end of a head of the block of cylinders is applied and put in action directly from a camshaft.

At movement on damp road it is recommended to press from time to time a brake pedal to remove from brake disks harmful inclusions. At the expense of centrifugal force water at movement is dumped from brake disks, however on them there is a thin film from fats, силиконов, the rests of rubber, greasing and a dirt which reduce efficiency of braking.

After installation new brake колодок they should be earned extra. On the first 200–300 km of run it is not recommended to make the maximum braking needlessly.

Корродированные brake disks cause vibrating effect which does not disappear at long braking at braking. In this case brake disks are subject to replacement.