Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10.3. Brake pipelines and hoses
THE GENERAL DATA

Unscrewing of a connecting nut of brake system with use of a special key

Brake tubes are applied to transfer of a brake liquid from the main brake cylinder to wheel brake cylinders. Connection of tubes with brake cylinders and switching centres is made конусными муфтами. The ends of tubes are pressed out and have the cone-shaped form for the corresponding size конусных carving apertures in brake cylinders or switching centres.

Before обжатием the ends of tubes the lock nut which after ввинчивания a cone-shaped surface in конусное the basis of a carving aperture presses and герметизирует a tube is put on them.

Brake hoses carry out mobile communications between mobile and motionless parts of the car. For reduction of losses of a brake liquid at removal of working brake cylinders clips for пережатия brake hoses are used.