Peugeot 406

Since 1996 of release

Repair and car operation


Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10.16. The unilateral valve of the vacuum amplifier of brakes

Removal

PERFORMANCE ORDER
1. Ослабьте a collar also disconnect a vacuum hose from the unilateral valve of the vacuum amplifier of brakes.
2. Take the valve from rubber ring consolidation, turning it in the parties and sipping on itself.
3. Remove condensing rubber ring from the vacuum amplifier of brakes.

Check

PERFORMANCE ORDER
1. Check up the unilateral valve on presence of damages. The valve can be checked up, blowing it in two directions. Air should pass through the valve only from outside the vacuum amplifier of brakes.
2. Check up a rubber condensing ring and a vacuum hose on deterioration and damages. If necessary – replace.

Installation

PERFORMANCE ORDER
1. Establish condensing rubber ring in the vacuum amplifier of brakes.
2. Insert the unilateral valve in the vacuum amplifier. Thus be careful not to damage a rubber condensing ring.
3. Connect to the valve a vacuum hose and fix its collar.
4. Start the engine and check up working capacity of the vacuum amplifier of brakes.