Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10.11. A support of a back wheel
THE GENERAL DATA

The prevention

On models with ABS disconnect the accumulator before any рассоединением brake system and repeatedly connect it after full connection of elements of brake system.


Removal

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports. Remove a corresponding back wheel.
2. Remove brake колодки.
3. Using a G-shaped clip, press a brake hose.
4. Clear a dirt round connection of a brake tube and a support. Unscrew a nut and disconnect a brake pipe from a support. Close stoppers a brake pipe and an aperture in a support.
5. Unscrew a bolt of fastening of a support, remove a protective head from the directing plug and unscrew a bolt of a directing finger. Remove a support.

Repair

Repair of a back support is similar to repair of a forward support (cм. Subsection 10.10).

Installation

PERFORMANCE ORDER
1. Clear a carving of bolts of directing fingers and cover with their means against unscrewing (Loctite Frenetanch).
2. Establish a support and screw in bolts of fastening of a directing finger, tightening their demanded moment.
3. Establish a protective head on directing plugs.
4. Connect a brake pipe to a support and tighten a connecting nut the demanded moment. Remove a clip from a brake hose.
5. Establish brake колодки.
6. Remove air from brake system.
7. Establish a wheel and lower the car.