Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. A suspension bracket and a steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward bearings of a nave
   11.4. A forward rack
   11.5. Repair of a forward rack
   11.6. The bottom lever of a forward suspension bracket
   11.7. The bottom spherical hinge of a forward suspension bracket
   11.8. The stabilizer of cross-section stability of a forward suspension bracket
   11.9. A side scene of the stabilizer of cross-section stability of a forward suspension bracket
   11.10. The bottom frame of a forward suspension bracket
   11.11. A nave of a back wheel
   11.12. Replacement of bearings of a back nave
   11.13. The shock-absorber of a back suspension bracket
   11.14. A cylindrical spring of a back suspension bracket
   11.15. A pin of a nave of a back suspension bracket
   11.16. The bottom lever of a back suspension bracket
   11.17. The top lever of a back suspension bracket
   11.18. The directing lever of a back suspension bracket
   11.19. Draught of a back suspension bracket
   11.20. The stabilizer of cross-section stability of a back suspension bracket
   11.21. A side scene of the stabilizer of cross-section stability of a back suspension bracket
   11.22. A steering wheel
   11.23. A steering column
   11.24. An intermediate shaft of a steering column
   11.25. The ignition lock
   11.26. The steering mechanism
   11.27. Replacement of protective covers of the steering mechanism
   11.28. Removal of air from system of a steering with the amplifier
   11.29. The pump of the amplifier of a steering
   11.30. The spherical hinge of steering draught
   11.31. Steering draught
   11.32. Corners of installation of wheels
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

11.17. The top lever of a back suspension bracket
THE GENERAL DATA

Removal of the bottom frame

Internal шарнирный the bolt of the top right lever is specified by an arrow.

THE RIGHT LEVER

Removal

For removal internal шарнирного a bolt of the top right lever it is necessary to lower completely a back suspension bracket and the bottom frame (fig. Removal of the bottom frame see). It is necessary to carry out THAT at station.

THE LEFT LEVER

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports. Remove a corresponding back wheel.
2. Establish a jack under the external end of the bottom lever and lift a jack so that the spring has been slightly compressed.
3. Unscrew nuts, take internal шарнирные bolts.
4. Unscrew nuts, take external шарнирные bolts and take the lever from under the car, releasing it thus from fastening of a cable of a manual brake.
5. Clear the lever of a dirt and an anticorrosive covering and check up its condition.

Installation

PERFORMANCE ORDER
1. Grease шарнирные bolts with greasing Molykote G Rapide Plus.
2. Establish the lever into place, insert шарнирные bolts and screw on them nuts, without tightening definitively.
3. Establish a wheel and lower the car. Shake the car that all elements of a suspension bracket have risen on the places. Tighten nuts of fastening top шарнирных bolts the demanded moment.