Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
- 13. An electric equipment
   13.1. Technical data
   13.2. Detection of not closed chain
   13.3. Safety locks and the relay
   13.4. Switches
   13.5. Bulbs of external illumination
   13.6. Lamps of illumination of salon
   13.7. Devices of external illumination
   13.8. Adjustment of light of headlights
   13.9. A combination of devices
   13.10. The multipurpose display
   13.11. Прикуриватель
   13.12. Hours
   13.13. A sound signal
   13.14. The screen wiper lever
   13.15. The screen wiper and draught engine
   13.16. A back screen wiper
   13.17. Стеклоомыватель
   13.18. An automobile radio tape recorder
   13.19. A column (dynamics)
   13.20. The aerial
   13.21. A cruise-control control system
   13.22. Anticreeping system and an engine immobilizer
   13.23. Electric units of forward sitting
   13.24. A safety pillow
   13.25. Elements of a pillow of safety
   + 13.26. Electric schemes
+ 14. The basic malfunctions


13.21. A cruise-control control system
THE GENERAL DATA

The cruise-control control system copes vacuum. The main elements of system: the electronic control device (ECU), the vacuum pump, the electromagnetic valve, the executive mechanism and a cable. The system copes the switch on a steering column and switches on a brake and coupling pedal.

Removal and installation

PERFORMANCE ORDER
The electronic control device (ECU)
1. Block ECU is located in a back part of a ware box. Remove the negative plug from the accumulator.
2. Take шарнирные fingers and uncover a ware box from the panel of devices. Unscrew the screw and uncover the panel of devices for access to block ECU.
3. Remove percussion caps and a cover of the bottom part of the panel of devices from outside the passenger.
4. Disconnect an electric socket, unscrew screws of fastening and remove block ECU from the bottom part of the panel of devices.
The vacuum pump
5. The vacuum pump is located in a motor compartment. Remove the negative plug from the accumulator.
6. Disconnect an electric socket and a vacuum hose from the pump. Unscrew screws and remove the pump from an arm.
The electromagnetic valve
7. The electromagnetic valve is located on an arm of fastening of the vacuum pump.
8. Remove the negative plug from the accumulator, remove from the electromagnetic valve an electric socket and a vacuum hose.
9. Unscrew screws and remove the electromagnetic valve from an arm in a motor compartment.
The executive mechanism and cable
10. Remove a cable from the spherical hinge of a cam of a throttle. Remove скобу fastenings and take a cover of a cable from an arm.
11. Disconnect a vacuum hose from the executive mechanism, unscrew a nut and take the executive mechanism and a cable from a motor compartment.
12. If necessary remove скобу fastenings of a cover of a cable and separate a cable from the executive mechanism.
13. Installation is made in sequence, return to removal.