Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
- 13. An electric equipment
   13.1. Technical data
   13.2. Detection of not closed chain
   13.3. Safety locks and the relay
   13.4. Switches
   13.5. Bulbs of external illumination
   13.6. Lamps of illumination of salon
   13.7. Devices of external illumination
   13.8. Adjustment of light of headlights
   13.9. A combination of devices
   13.10. The multipurpose display
   13.11. Прикуриватель
   13.12. Hours
   13.13. A sound signal
   13.14. The screen wiper lever
   13.15. The screen wiper and draught engine
   13.16. A back screen wiper
   13.17. Стеклоомыватель
   13.18. An automobile radio tape recorder
   13.19. A column (dynamics)
   13.20. The aerial
   13.21. A cruise-control control system
   13.22. Anticreeping system and an engine immobilizer
   13.23. Electric units of forward sitting
   13.24. A safety pillow
   13.25. Elements of a pillow of safety
   + 13.26. Electric schemes
+ 14. The basic malfunctions

13.24. A safety pillow
THE GENERAL DATA

Detachment of an electric socket from the block of management of system of a pillow of safety

On the cars equipped with a pillow of safety from outside of the driver, there is a word “AIRBAG” on the central part of a steering wheel. In the presence of a safety pillow from outside the forward passenger on the top part of the panel of devices there is a word “AIRBAG”. The safety system includes a pillow of safety with gas generators, the block of management with the gauge of collision and an alarm system lamp in panels of devices. At each inclusion of ignition the safety system makes self-diagnostics. It is carried out in a current of 6 seconds. The lamp of the alarm system of system of safety on a combination of devices at this time burns.

Before performance of any actions on safety system remove the negative plug from the accumulator and wait at least 2 minutes. Remove the central console and disconnect the main electric socket from the block of management of safety system. After performance of works connect an electric socket to the block of system of safety and establish the central console. Check up that in salon of the car anybody is not present, connect the accumulator and through an open door of the driver include ignition, being outside of the car.


The prevention

The safety pillow should not be exposed to temperature influence above 100 With.

Hit on a pillow of safety of solvents or clearing means is forbidden.

Disconnect contact of a wire of the block of management from a safety pillow at carrying out of electrowelding works on the car.