Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   - 3.1. Petrol engines
      3.1.1. Technical data
      3.1.2. Check of pressure of compression
      3.1.3. Mechanism installation timing
      3.1.4. A cover of a head of the block of cylinders
      3.1.5. A pulley of a cranked shaft
      3.1.6. A casing of a gear belt
      3.1.7. A gear belt
      3.1.8. The mechanism of a tension of a gear belt and pulleys
      3.1.9. Replacement of a sealing ring of a cam-shaft
      3.1.10. A cam-shaft and pushers
      3.1.11. Check and adjustment of backlashes of valves of engines of 1.6 litres
      3.1.12. A head of the block of cylinders
      3.1.13. The oil pallet
      3.1.14. The oil pump
      3.1.15. An oil radiator
      3.1.16. Replacement of consolidations of a cranked shaft
      3.1.17. A flywheel
      3.1.18. A suspension bracket of the power unit
   + 3.2. Diesel engines
   + 3.3. Engine repair
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

3.1.5. A pulley of a cranked shaft Removal

PERFORMANCE ORDER
1. Remove auxiliary приводной a belt.
2. For fixing коленвала the engine from проворачивания the assistant should include the fourth transfer and press against the stop a foot brake. At this time ослабьте a bolt of fastening of a pulley коленвала. If the engine is removed from the car, fix a gear wreath of a flywheel a clamp. At all do not fix коленвал, using an aperture in a pulley for mechanism installation timing.
3. Unscrew a bolt and remove a pulley with коленвала. If the pulley is established on sliding landing on коленвал with application шпонки or a pin, remove them. If a pulley напрессован on коленвал, remove it by means of a stripper.

Installation

PERFORMANCE ORDER
1. Establish segment шпонку in a flute коленвала. Establish a pulley on коленвал, combining a groove on a pulley with segment шпонкой.
2. Clear a carving of a bolt of fastening of a pulley and grease with its means against unscrewing (Peugeot recommends use Loctite Frenetanche).
3. Screw up a bolt with a washer of fastening of a pulley.
4. Establish and adjust a tension auxiliary приводного a belt.