Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
- 12. A body
   12.1. The general information
   12.2. Care of a body
   12.3. Care of an upholstery and rugs
   12.4. Repair of insignificant damages of a body
   12.5. Repair of strong damages of a body
   12.6. A forward bumper
   12.7. A back bumper
   12.8. A cowl
   12.9. A cable of the lock of a cowl
   12.10. The cowl lock
   12.11. Doors
   12.12. A door upholstery
   12.13. The lock and handles of opening of a door
   12.14. Glasses of doors
   12.15. A luggage carrier cover
   12.16. The luggage carrier lock
   12.17. A back door
   12.18. The lock of a back door
   12.19. System of the central blocking
   12.20. Electric стеклоподъемники
   12.21. External rear-view mirrors
   12.22. Front and back has flown down
   12.23. The hatch
   12.24. Overlays and emblems
   12.25. Seats
   12.26. The mechanism of a tension of a seat belt of a forward seat
   12.27. Seat belts
   12.28. Salon furnish
   12.29. The central console
   12.30. The panel of devices
+ 13. An electric equipment
+ 14. The basic malfunctions

12.19. System of the central blocking
THE GENERAL DATA

The engine of the central blocking of a door-lock is an integral part of the lock and cannot be replaced separately from the lock.

Removal and installation

PERFORMANCE ORDER
The engine of the lock of a cover of a luggage carrier
1. Open a luggage carrier cover, take percussion caps and remove luggage carrier furnish.
2. Disconnect an electric socket, unscrew screws (are specified by arrows) fastenings of the engine of the lock of a cover of a luggage carrier.
3. Remove the engine from a luggage carrier cover, disconnecting it from draught.
The engine of the lock of a back door
4. Remove the lock of a back door.
5. Unscrew screws (are specified by arrows) fastenings, disconnect from the engine draught.
6. Remove the engine from a back door.
The electronic control device (ECU)
7. The system of the central blocking consists of three blocks of management: the receiver, the central block of management of locks and the management block. All blocks are located under the panel of devices from outside the passenger. For access to blocks open a cover of a ware box and remove it from hinges. Unscrew screws of an additional cover in the panel of devices.
8. A screw-driver wring out скобы fastenings and take a cover from a nest.
9. Management blocks are located as follows: the receiver – at the upper left, the central block ECU – at the upper right, under them – the management block. For removal of blocks disconnect an electric socket, release fixing скобу and take the block (it is specified by an arrow) from an installation suspension bracket.
10. To remove the management block, disconnect an electric socket, unscrew a bolt of fastening of the block to a partition of a motor compartment. Unscrew screws of fastening and take the management block.
11. Installation is made in sequence, return to removal.