Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   - 3.3. Engine repair
      3.3.1. Technical data
      3.3.2. Removal and engine and transmission installation
      3.3.3. Removal and installation of engines from an automatic transmission
      3.3.4. Engine repair
      3.3.5. Removal and installation of a head of the block of cylinders
      3.3.6. Dismantling of a head of the block of cylinders
      3.3.7. Clearing and survey of a head of the block of cylinders
      3.3.8. Assemblage of a head of the block of cylinders
      3.3.9. Removal of pistons from rods
      3.3.10. Removal коленвала
      3.3.11. The block of cylinders
      3.3.12. Pistons and rods
      3.3.13. Коленвал
      3.3.14. Survey radical and шатунных bearings
      3.3.15. Engine balance of assembly at major repairs
      3.3.16. Installation of piston rings
      + 3.3.17. Installation коленвала and check of working backlashes of radical bearings
      + 3.3.18. Installation of pistons
      3.3.19. Start of the engine after major repairs
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

3.3.9. Removal of pistons from rods
PERFORMANCE ORDER
1. Remove a head of the block of cylinders, the pallet and the oil pump.
2. If there is a deposit in the top part of the cylinder, remove its scraper from a soft material. Step presence in the top part of the cylinder testifies to excessive deterioration of the cylinder and necessity расточки engine cylinders.
3. Using a hammer and кернер or a paint note position of a cover of the bottom head of a rod and cylinder number (in drawing the cylinder №3 is shown).
4. Turn коленвал so that pistons of 1st and 4th cylinders were established in НМТ.
5. Turn away a nut of fastening of a cover of the bottom head of a rod of the first cylinder. Remove the bottom cover of a rod.
6. For prevention of possibility of damage of necks коленвала rod hairpins wind hairpins with any soft material or put on them corresponding tubules from a soft material.
7. Using the hammer handle, push out the piston upwards the block of cylinders and take it from the block of cylinders.
8. On the bottom head of a rod establish a cover of a rod and screw nuts that will allow to hold them in the complete set and not to mix in places.
9. Similarly remove the piston of the fourth cylinder.
10. Turn коленвал on 180 for installation of pistons of 2nd and 3rd cylinder in НМТ and similarly remove pistons.