Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   - 3.3. Engine repair
      3.3.1. Technical data
      3.3.2. Removal and engine and transmission installation
      3.3.3. Removal and installation of engines from an automatic transmission
      3.3.4. Engine repair
      3.3.5. Removal and installation of a head of the block of cylinders
      3.3.6. Dismantling of a head of the block of cylinders
      3.3.7. Clearing and survey of a head of the block of cylinders
      3.3.8. Assemblage of a head of the block of cylinders
      3.3.9. Removal of pistons from rods
      3.3.10. Removal коленвала
      3.3.11. The block of cylinders
      3.3.12. Pistons and rods
      3.3.13. Коленвал
      3.3.14. Survey radical and шатунных bearings
      3.3.15. Engine balance of assembly at major repairs
      3.3.16. Installation of piston rings
      + 3.3.17. Installation коленвала and check of working backlashes of radical bearings
      + 3.3.18. Installation of pistons
      3.3.19. Start of the engine after major repairs
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

3.3.4. Engine repair
THE GENERAL DATA

It is the most convenient to make works on the engine if it is established on a special bed.

Before repair of the engine it is necessary to remove from it:

 – The generator;
 – The thermostat and a branch pipe of an exit of a cooling liquid (petrol engines);
 – A casing of the thermostat and the fuel filter (diesel engines);
 – A pipe for a measuring instrument of level of oil;
 – Electric switches and gauges;
 – Inlet and final collectors;
 – The oil filter;
 – Basic arms of the engine;
 – A flywheel.

If it is necessary to make only repair of the block of cylinders, коленвала, pistons and rods it is necessary to remove a head of the block of cylinders, the oil pallet, the oil pump and a gear belt.

In need of carrying out of full major repairs it is necessary to remove from the engine:

 – Inlet and final collectors;
 – A gear belt, pulleys and the tension mechanism;
 – A head of the block of cylinders;
 – A flywheel;
 – The oil pallet;
 – The oil pump;
 – Pistons with rods;
 – коленвал.