Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. Transmissions
   - 8.1. A mechanical transmission
      8.1.1. Technical data
      8.1.2. Oil replacement in a transmission
      8.1.3. Management of a gear change (transmission BE3)
      8.1.4. A trosovyj drive of a gear change (transmission ML5T)
      8.1.5. Replacement of sealing rings
      8.1.6. The switch of a lantern of a backing
      8.1.7. The gauge of a drive of a speedometer
      8.1.8. Removal and installation of transmission ВЕ3
      8.1.9. Mechanical transmission ML5T
   + 8.2. An automatic transmission
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

8.1.7. The gauge of a drive of a speedometer
THE GENERAL DATA

The gauge of a drive of the speedometer, established on transmission ML5T


Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove a mudguard from under the engine. The gauge of a drive of a speedometer is located on a back part картера transmissions near to the internal end of the right power shaft. Depending on model the speedometer drive can be carried out by a cable or an electric way.
2. On models with тросовым a speedometer drive take a pin and remove a cable of a drive of a speedometer. On models with an electric drive of a speedometer disconnect an electric socket.
3. Unscrew a fastening bolt together with the heat-shielding screen (where is available).
4. Remove the gauge of a drive of a speedometer or the block of gear wheels of a drive of a speedometer with картера transmissions together with a sealing ring of round section.
5. If necessary the gear wheel can be taken from the case and after that it is possible to replace a sealing ring in the top part of the case. Check up a gear wheel on deterioration and if necessary replace.
6. If the conducted gear wheel is worn out or damaged, it is necessary to investigate a leading gear wheel in картере transmissions.
7. For removal of a leading gear wheel of a drive of a speedometer on transmission ВЕ3 remove the right power shaft from a transmission. Unscrew three bolts of fastening.
8. Then remove the case of a drive of a speedometer together with a sealing ring of round section. Remove a leading gear wheel from differential together with adjusting linings.

Installation

PERFORMANCE ORDER
1. Establish adjusting linings on differential, then a leading gear wheel of a drive of a speedometer, combining thus adjusting ledges (are specified by arrows). Establish a new sealing ring of round section on a back part of the case of a drive of a speedometer, then establish the case into place and screw bolts. Establish a power shaft.
2. Grease working edges of a sealing ring and a conducted shaft of a gear wheel and establish a gear wheel in the case of a drive of a speedometer.
3. Establish a new sealing ring of round section on the case of a drive of a speedometer. Establish assemblage on a transmission.
4. Establish a thermofilter and fix a bolt.
5. On models with an electric drive of a speedometer connect an electric socket. On models with тросовым a speedometer drive connect a cable of a drive of a speedometer.
6. Establish a mudguard under the engine and lower the car.