Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Technical data
   7.2. A coupling cable
   7.3. A coupling pedal
   7.4. A hydraulic control system of coupling
   7.5. Leading knot of coupling
   7.6. The mechanism of deenergizing of coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

7.2. A coupling cable

Removal

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. In car salon open a cover of an immobilizer and turn on 90 a clamp of a cover of a box with fuses. Disconnect an electric socket from колодки, unscrew screws of fastening and remove the bottom panel from outside the driver.
3. Remove the air filter and the inlet air channel.
4. In a motor compartment remove a cable of deenergizing of coupling from the lever of deenergizing of coupling and a cover of a cable from an installation suspension bracket, disconnect a cable from картера transmissions.
5. In car salon remove a cable from a coupling pedal.
6. In a motor compartment take from a partition of a motor compartment the plug and take a cable, releasing it from скоб fastening and clips.
7. Check up a condition of a cable of coupling on presence of deterioration or other defects.

Installation

PERFORMANCE ORDER
1. Grease a cable of coupling and spend it through a partition of a motor compartment.
2. Establish a coupling pedal in the top position.
3. Fix the end of a cable of coupling for a pedal.
4. In a motor compartment establish a coupling cable on картер transmissions and the lever of deenergizing of coupling. Fix in a motor compartment a coupling cable скобами and clips.
5. Some times press a coupling pedal that the mechanism of automatic control of coupling was established into position and coupling worked normally.
6. Establish earlier removed elements in the bottom part of the panel.
7. Establish the air filter and connect the accumulator.