Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
- 5. Fuel system
   - 5.1. The power supply system of petrol engines
      5.1.1. Technical data
      5.1.2. The air filter and inlet channels
      5.1.3. An accelerator cable
      5.1.4. An accelerator pedal
      5.1.5. System of injection of fuel
      5.1.6. Pressure removal in fuel system
      5.1.7. The fuel pump
      5.1.8. A fuel tank
      5.1.9. Check of fuel system
      5.1.10. The case throttle заслонки
      5.1.11. System of injection Bosch Motronic MP511
      5.1.12. System of injection Magneti Marelli 8P
      5.1.13. An inlet collector
      5.1.14. A final collector
      5.1.15. System of release of the fulfilled gases
   + 5.2. Fuel system of diesel engines
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

5.1.13. An inlet collector

Removal

MODELS IN VOLUME OF 1.6 LITRES

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. Remove the air filter.
3. Remove a cable of an accelerator from a drive throttle заслонки and disconnect fastenings of a cover of a cable.
4. Unscrew two bolts of fastening of an arm of electroconducting to the top part of a collector and move an arm with wires and hoses aside.
5. Release скобы and remove sockets from four fuel atomizers.
6. Remove submitting and returnable fuel hoses from outside a collector.
7. Ослабьте collars also remove a hose of the vacuum amplifier of brakes and a ventilation hose картера from the top part of a collector. If necessary mark hoses.
8. Unscrew nuts of fastening of a collector and take a collector from a motor compartment. Remove two linings of a collector.

ENGINES OF 1.8 AND 2.0 LITRES

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. Remove the case of throttles, a fuel highway and atomizers.
3. Ослабьте collars also remove a hose of the vacuum amplifier of brakes and a ventilation hose картера from the top part of a collector. If necessary mark hoses.
4. Where it is used, unscrew a bolt of fastening of a pipe of a measuring instrument of level of oil to a collector.
5. Unscrew nuts and bolts, крепящие a collector to a head of the block of cylinders, and take a collector from a motor compartment. Remove collector linings.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Consider following moments:
     – Clear interfaced surfaces of a collector and a head of the block of cylinders of traces of old linings. Establish new linings and a collector;
     – Check up that earlier removed hoses are established on the places;
     – Adjust an accelerator cable.