Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
- 5. Fuel system
   - 5.1. The power supply system of petrol engines
      5.1.1. Technical data
      5.1.2. The air filter and inlet channels
      5.1.3. An accelerator cable
      5.1.4. An accelerator pedal
      5.1.5. System of injection of fuel
      5.1.6. Pressure removal in fuel system
      5.1.7. The fuel pump
      5.1.8. A fuel tank
      5.1.9. Check of fuel system
      5.1.10. The case throttle заслонки
      5.1.11. System of injection Bosch Motronic MP511
      5.1.12. System of injection Magneti Marelli 8P
      5.1.13. An inlet collector
      5.1.14. A final collector
      5.1.15. System of release of the fulfilled gases
   + 5.2. Fuel system of diesel engines
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions


5.1.10. The case throttle заслонки

Removal

PERFORMANCE ORDER
1. Disconnect the negative plug of the accumulator.
2. Remove the air filter.
3. Remove a cable of an accelerator from a drive throttle заслонки.
4. Remove electric sockets from the gauge of position throttle заслонки, elements of heating, the gauge of temperature of arriving air and the engine of management of idling.
5. Remove a vacuum hose and a ventilation hose картера the engine.
6. Where it is necessary, unscrew bolts or screws and remove a suspension bracket of a cable of an accelerator.
7. Unscrew bolts and remove the case throttle заслонки from an inlet collector together with a lining of round section with which it is necessary to replace.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Consider following moments:
     – Always use a new sealing ring which are established on a collector then accurately establish the case throttle заслонки;
     – Check up correctness of installation before the removed hoses;
     – Check up correctness of installation before the removed sockets;
     – Establish an accelerator cable.