Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical data
      3.2.2. Check of pressure of compression
      3.2.3. Mechanism installation timing
      3.2.4. A cover of a head of the block of cylinders
      3.2.5. A pulley of a cranked shaft
      3.2.6. A casing of a gear belt
      3.2.7. A gear belt
      + 3.2.8. Pulleys of a gear belt
      + 3.2.9. The right engine mount and the mechanism of a tension of a gear belt
      3.2.10. A directing roller of a gear belt
      3.2.11. A cam-shaft and pushers
      3.2.12. Check and adjustment of backlashes of valves
      + 3.2.13. Removal and installation of a head of the block of cylinders (engines of 1.9 litres)
      3.2.14. Removal and installation of the oil pallet
      3.2.15. Removal and installation of the oil pump
      - 3.2.16. Replacement of sealing rings коленвала
         3.2.16.1. The right sealing ring коленвала
         3.2.16.2. The left sealing ring коленвала
         3.2.16.3. The right sealing ring of a cam-shaft
         3.2.16.4. The left sealing ring of a cam-shaft
   + 3.3. Engine repair
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

3.2.16.3. The right sealing ring of a cam-shaft
PERFORMANCE ORDER
1. Remove a cam-shaft pulley.
2. Take a sealing ring, using the special tool. Alternatively drill two small apertures in an end face of a sealing ring, screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest.
3. Clear a nest of a sealing ring and a condensed surface of a cam-shaft.
4. Grease a new sealing ring with pure engine oil and establish it on a cam-shaft.
5. Press a sealing ring into a nest for what use bolt М10 with a corresponding washer.
6. Establish a cam-shaft pulley.