Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
- 2. Maintenance service
   - 2.1. Petrol models
      2.1.1. Technical data
      2.1.2. Periodicity of service
      - 2.1.3. Maintenance service
         + 2.1.3.1. Each 15000 km or 12 months
         + 2.1.3.2. Each 30 000 km
         - 2.1.3.3. Each 60000 km
            2.1.3.3.1. Replacement of spark plugs and check of system of ignition
            2.1.3.3.2. Replacement of a filtering element of the air filter
            2.1.3.3.3. Replacement of the fuel filter
            2.1.3.3.4. Check and replacement auxiliary приводного a belt
            2.1.3.3.5. Check of level of oil in a manual transmission
            2.1.3.3.6. Check back brake колодок
            2.1.3.3.7. Replacement of a brake liquid
         + 2.1.3.4. Each 120000 km or alternate years
   + 2.2. Diesel models
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

2.1.3.3.5. Check of level of oil in a manual transmission
THE GENERAL DATA

The prevention

After вывинчивания stoppers of measurement of level of oil on it it is necessary to establish new consolidation.


PERFORMANCE ORDER
1. Lift the car on the stationary lift or establish it over a viewing hole in horizontal position. Measurement of level of oil make at least in 5 minutes after engine deenergizing. If to check oil level at once after engine deenergizing, the result will be incorrect since the oil part remains the transmission distributed on elements.
2. Remove the left forward wheel, unscrew screws and скобы fastenings under a wing for access to a stopper of pouring / of level of oil.
3. Wipe area round a stopper which can be defined as a bolt with the biggest head on a face cover of a transmission.
4. Use a wrench for easing of a stopper of pouring / of level of oil in a transmission.
5. Unscrew a stopper and remove from it consolidation.
6. Oil level should be at the bottom level of a jellied aperture.
7. If at oil pouring in a transmission there was its overflow check up that the car is established strictly horizontally and allow to flow down to surpluses of oil in the corresponding container.
8. When will reach normal level of oil in a transmission, establish on a stopper new consolidation and screw up a stopper the corresponding moment. Wipe a transmission from oil traces. Establish a protective arch and a wheel.
9. Necessity frequent доливки oils in a transmission testifies to leak of oil which should be eliminated.